Hence the term selling someone A Bill of Goods!?!
Of course it makes me wonder what the other numbers represent
Well there you have it. Thanks
Greetings....I have not yet reinstalled my heater box after recently getting the engine back into the vehicle...so the hose is just bypassing for...
Front or rear? Rear I surmise or was there supposed to be 2, or is the assumption one and the same.
Here's a picture of my breather pipe on a non-smog pump version. Leaves a small smudgy circle of grime on the hood is all. [ATTACH] If it...
[ATTACH] Found in my box of parts...I get the 4.89 gearing I guess but where would this be mounted? Thanks
Mine is a 67 with no air pump, and has a similar tube on the oil bath filter, albeit it points upward and is open so I think you are GTG IMHO.
I just replaced my spring with the one from a corvette 55-81 all the same, any corvette resto place has them, so easy a caveman can do it, either...
Ok two more pics showing the difference in a blow-up if you will. As you can see the height between old..working...new not working clutch plates...
Since we're in the learning mode, and since I'm having trouble with my clutch installation, I thought maybe I am also that stupid......alas though...
Much easier if you can work on a flat surface, support the frame, inside up, on a set of padded saw horses with two 1x4s cut to be a few inches...
[ATTACH] Does anyone reproduce the Meyer Hardtop decals....would be cool!?![ATTACH]
FWIW my 67 Dauntless has the same "rocker type" lockdown clamp as shown by Ollie 2009, and it's also what's shown in parts manual Group 15 L-7...
If it isn't leaking its low on fluid, I think that's on the third page of the owner's manual.
No problem. appreciate you all the same.
Yeah, mine had almost twice that offset. Since you have your tape measure out, how much space do you have between the drivers side exhaust...
By 3.5 shims I mean 3 ea 1/4" shims and 1 ea 1/8" shim if you will. I took out one of the 1/4" and the 1/8" shims leaving 2 shims 1/4" ea in and...
Picture of the issue[ATTACH] Parts manual only shows one spacer at the cross member, I might look at taking a couple of those out to see if it...
To clarify, it's been my Jeep, but someone else took it apart...long story that falls along the lines of NO GOOD DEED GOES UNPUNISHED. Anyhow,...
Separate names with a comma.