I've ordered a set of the 16" repops from KaiserWillys.com for my 66 CJ5 that is "almost" stock. It has a 2 1/2" lift underneath it. Original...
Can I mount 235/85r16's on a 16x6 re-pop from kaiserwillys.com ? Let me know what y'all think. Thanks,,,
KaiserWillys.com has new 16" steel wheels advertised, but they're OmixAda. I have heard to stay away from that manufacturer. It's the only place I...
I'm about 80% complete on a frame off restoration of my 66 CJ5. I have a 2 1/2" suspension lift on her right now. My question is this: I'm going...
Just ordered a set of 16" Steel Civilian Rims from KaiserWillys. I know that all of the original tires that were mounted on these rims required...
OK,so today I was mating up my stock DANA 18 transfer case to the stock T86AA. After "tightening" the rear transmission input nut,,,,,,, it all...
Anyone know of where I can get my hands on a dash panel for my 66? Haven't placed a "wanted' add up yet,,,, it will be my next move, but I'd...
Got both the T86AA and DANA 18 cleaned up and painted. I'm ready to bolt them together and have purchased a seal kit from kaiserwillys.com. My...
Hope everyone can open this link,,,,, I'm a bit computer illiterate. Question - Does this look right. It's a replacement rear...
OK, so I'm taking the combo to a machine shop tomorrow. As far as the motor goes,, when I parked it - no knocks, no smoke, good starts,,, just oil...
OK,,,, finally decided to tear into the motor. 225 V6 Dauntless. New experience for me. How new? Well let's just say that it was the first time I...
Well, I thought I had taken enough pictures during tear down, guess not. I need some pics/help on the brake line lay out on this thing...
So I managed to "booger" up the threads on the axle shaft, and now the castle nut will not go on. Does anyone know what the threads per inch on a...
Ok, so the only history I have with installing/seating wheel bearings is with trailer axles. I greased the bearings and installed the lockwaser...
Anybody know where I can get a pre-bent brake line kit for a 66 CJ5?? I could do it myself,,,,, but bending, cutting, flaring,,, would just like...
Need a little help..... 66 Cj5 with 2.5" of lift. Im a newbie to the jeep world, and am working on a frame off restoration. Frame's done, axles...
Hey guys, i got a dilemna. When I began tearing the front axle on my 66 cj5 apart for rebuild, there were no inner seals. It is a Dana 27. I'm...
Got a Dana 44 under a 66 CJ5. Attempting to pull the axle shafts to replace bearings, clean backing plate, replace seals, etc. Paaenger side hub...
Separate names with a comma.