1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

68 225 V6 - Smog Question

Discussion in 'Early CJ5 and CJ6 Tech' started by gtolosa, Jan 7, 2005.

  1. gtolosa

    gtolosa New Member

    Sorry about this everyone, I saw a post on this before, but looking around I could not find it.

    What was the verdict for the size/type of bolt to replace the smog line holes on the manifold?

    Should I also use some type of seal compound?

    After removing the smog pump and related gear, will I need to adjust timing? other adjustments?

    Thanks.
     
    gtolosa, Jan 7, 2005
    #1
  2. Mcruff

    Mcruff Earlycj5 Machinist

    1/2-13 threads, and yes I would use some kind of sealant and make sure the bolts or set screws are stainless.
     
    Mcruff, Jan 8, 2005
    #2
  3. Jim Wiseman

    Jim Wiseman New Member

    I just replaced my crimped-off'ed tubes (tubal litigation?) with six 1/2-13x5/8 hex socket set screws this weekend. A little gas teflon tape on the threads and the holes are perfectly plunged.
     
    Jim Wiseman, Feb 7, 2005
    #3