here we go again took 3 months to finish my 53 cj 3b

here is some of my before after pictures all hand built no bolt on from the shackels to the hangers the axle perches , it has chevy half ton narrowed dana 44's front and rear , detroit in the rear richmond in the front with disk brake and 36" super swamper what a misrable build everything was crooked or bent, 3-4 times each installing front and rear cutting and retacking nothing fit write drives good at 60 no wiggles ,think this might be the last one probally not though[/URL][/IMG][/URL][/IMG][/URL][/IMG][/URL][/IMG][/URL][/IMG][/URL][/IMG]

 

Rear winch? Very nice.

 

yes barely fit behind the rear seat bolted it through the frame 6,000lb warn in the rear and 8,000 lb upright warn in front still have to install my tire carrier im going to have to figure out the 36" spare so it wont sag to much might have to make a little taller perchs i want it to sit level sure drives nice with the lifted YJ springs

 

Very nice. I like the look.

 

Very nice! 3 months is all it took? That's impressive.


Sent from my iPhone

 

How much lift on the YJ springs? I used stock from Full Traction and they are beyond flat after a year and a half. I'm either going to try add-a-leafs or 1" lift YJ's. I love the ride, but have lost a lot of my up-travel.

 

2 1/2 lift springs with spring it over and shackel reversal i think its about 7-8 inches, i dont no the brand of the springs i gave a $100 bill for them