1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Dana 20 Tc

Discussion in 'Intermediate CJ-5/6/7/8' started by dbender, Nov 9, 2020.

  1. dbender

    dbender 1974 CJ5 I6 258

    Ok, stumped a little here. going through the Spicer 20 TC, It has obviously been opened up before. there is a spacer on the front output shaft between the output shaft sliding gear and the front output shaft gear. I have reviewed several break downs and none of them show this spacer?
    What to do? preload sets up ok, if i remove i don't think I will be able to get preload on the bearings
    Is this supposed to be here?
    THX
    Dave IMG_4342.jpg
     
    dbender, Nov 9, 2020
    #1
  2. dbender

    dbender 1974 CJ5 I6 258

    Correction, Not preload, but end play.
    without the spacer i may not be able to get proper end play
     
    dbender, Nov 9, 2020
    #2
  3. nickmil

    nickmil In mothballs.

    Yes on that 20 it is supposed to be there. It is a thrust washer for the gear and is sandwiched between the gear and bearing.
     
    nickmil, Nov 10, 2020
    #3
  4. dbender

    dbender 1974 CJ5 I6 258

    RGR
    thx
    it stays
     
    dbender, Nov 10, 2020
    #4