floor pans or plates what ones do i need???

well the po hack my fire wall bad on my 52 m38ai.so i bought a new tranny top plate and my floor pans are in working order but what else bolts in there? http://i21.ebayimg.com/01/i/04/fa/4c/8f_2.JPG thats a top frool plate do i need that any help is greatly appreciated. its like trying to put a puzzle together with out being able to see the peices! thanks,jared

 

there is a plate that goes in the upper left corner that goes above the sterring cloumn. It is sort of a rectangular piece with an aprox 45 dgree bend in it and a semi circle cut out in the lower right where it goes around the top half of the column. Of course you also need the round brack master access cover too.

 

yup, that should be there as well... the tranny cover (larger one that bolts to the floor) will bolt on top of the lower edge of that panel.

 

what does the round brack master cover look like,i got the little one in the left corner (pending) is it the one in the picture or do you have a pic so i know what it is thanks,guys,jared

 

Whoops sorry on the typo. The master BRAKE cylinder access plate is oh.. about 5" in diameter with four bolt holes in it. Also it has a slightly raised center circle that is about 3" in diameter. I think it has a flat cut out on one edge too.

 

jcarson, got a pic of what you have to werk with in your Jeep? It'd help to see what's there in order to advise. Thanks!

 

well i got a better i dea since its trashed and has a v-8 im goonna start over and make a hole new one fire wall tranny plate and all thanks for the help guys,jared