1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Pulling pinion shaft rear cup?

Discussion in 'Early CJ5 and CJ6 Tech' started by Chuck, Dec 27, 2005.

  1. Chuck

    Chuck Sponsor

    I don’t own a bearing/cup puller and was wondering how best to remove? (D25)
     
    Chuck, Dec 27, 2005
    #1
  2. hudsonhawk

    hudsonhawk Well-Known Member

    If the pinion is out then use a steel rod and drive it out from the other side of the housing.
     
    hudsonhawk, Dec 27, 2005
    #2
  3. Glenn

    Glenn Kinda grumpy old man Staff Member

    Hammer and brass punch is the only way I know of.
     
    Glenn, Dec 27, 2005
    #3
  4. Evans

    Evans Former YJ owner

    Yep , pull the carrier out if it isn't already and the pinion then you can drive the bearing cup out with brass rod as mentioned...
     
    Evans, Dec 27, 2005
    #4
  5. Chuck

    Chuck Sponsor

    Thanks for the info guys just finished removing the oil seals, bearings and cups.
     
    Chuck, Dec 27, 2005
    #5