1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

dana 18 identification

Discussion in 'Early CJ5 and CJ6 Tech' started by baljoint, May 27, 2006.

  1. baljoint

    baljoint Member

    having trouble ID'n my trnsfr cse. Big hole? Small hole? 26 tooth 6 spline? what's it all mean? in a 56 willys f4 t 90 d18 d44 tapered help...need to know for warn OD purchase:?
     
    baljoint, May 27, 2006
    #1
  2. Old Bill

    Old Bill Aggressively passive....

    Hey there from Phoenix!

    My guess is that you have the small hole being a '56 and all, but I will defer to other's opinions.

    If you take off the rear (round) cover and snap a pic, I'm sure that someone here can give you the definitive skinny.
     
    Old Bill, May 27, 2006
    #2
  3. baljoint

    baljoint Member


    the PTO cover?
     
    baljoint, May 27, 2006
    #3
  4. scott milliner

    scott milliner Master Fabricator

    The flat plate on the back with five bolts holding it on.
     
    scott milliner, May 27, 2006
    #4
  5. scott milliner

    scott milliner Master Fabricator

    The hole size you would be looking for, is in between the transmission and the transfer case.
     
    scott milliner, May 27, 2006
    #5
  6. Glenn

    Glenn Kinda grumpy old man Staff Member

    And the hole size doesn't matter for the OD. You just need the tooth count of the gear you'll see when you remove the cover. That gear gets replaced by the one with the OD.
     
    Glenn, May 27, 2006
    #6
  7. baljoint

    baljoint Member

    i've been told its prbly a 26tooth 6 spline but dont buy anything till i check which ill do this wkend...thanks everyone
     
    baljoint, May 27, 2006
    #7