brake stop switch 72 Commando

hello fellow jeepsters I have a problem with the rear tail lights. everythigs good on the left side, the right side some times works.Replaced the brake stop switch that gave me brake lights. Now right side missing running light itermitintly.Read on your forum that it all runs throught the turn signal switch. does anybody have a wiring diagram for this. Tested wires at brake stop switch, both of them are hot. One wire was almost a volt the other was tewleve volts.




Please help Iam at my wits end

Matt

 

I think I'd be checking the ground on the right side light. When you get the 1 volt reading at the BL switch is that with the running lights on? Sounds like it's back feeding through the brake/turn signal circuit. There should be no voltage on the neutral side of the switch. Sorry I don't have a good wiring diagram to share. Might want to check the bulb and socket on that side too.

 

Check all your grounds, and add a ground at the light if needed.

 

Here's a wiring schematic....