I held the skid plate up to my tranny and t-case. Looks like the t-case hangs down a bit futher because of the new clocked position. And I dont...
Yes I would like to use the factory skid plate. I need the rubber type mount that bolts to the bottom of the tranny ?
I have deceided to go with the 727 behind the 360 in my 84 cj7. I got a rebuilt one for $300 and bolted up my dana 300 to it. My question is where...
I guess what I mean is to wire the engine itself,, alternator, starter solonoid, temp, oil, distributor, choke, etc. ??
I have an 84 cj7 and Im replacing the 258 with a 360. The motor is just a very basic engine. And I would like to get rid of the masses of wires...
Well turns out I have a much bigger problem, took the top off, the entire tranny is junk. Its had water sitting in it for quite some time, gears...
Nick, is the fix to buy a new top? Thanks Frank
I bought a t-176, dana 300 from a local guy, thinking I could use the t-176 in place of the existing t-5 and use it behind the 360 to be...
Thank You so much, this site is awesome and people like you too,,, Thanks again
Thanks,,,, ok so whats the method for removing the entire heater assembly ? Thanks again
My 1980 cj 5 heater core is leaking out on to the floor. How do I go about getting to it to replace it? I took a look under the dash and I didnt...
Thanks Roadhog I will check it out
Im replacing my 258 with a 360, my question is did the 6 cyl engines come with a 2 core radiator and the v-8 a three core? Thanks for any info
Anyone interested in trading for a t-176 and the right bell that would bolt it up to my 258 or a 304 or 360?
Would a t-176 bolt up to the bell I have now ?
Almost seems like I'd be better off going with a T-176 ?
I did not get a bell with it, the bell was still on a ford 302 that had been pulled out and was still there. I belive it is available as he was...
The version that I have is this one. "1976 was a crossover year for the Jeep CJ T18, featuring either the 4.02 or 6:32 first gear and no front...
Thanks guys for the great info,, sounds like the best thing to do would be to find a scout 2 dana 300 for a good deal, I will keep me eyes open...
I picked up a Jeep t-18 this weekend, Its the 4.02 first gear model and out of a 76 CJ. Im planning to install it in my 84 CJ7 in place of the T-5...
Separate names with a comma.