I have a 69 CJ5 with the Dauntless :v6:. Last year it ran fine with no issues but the brake master cylinder started acting up; the peddle would...
This is a follow-up to a previous thread posted by another member. Previous Thread I have heard numerous threads about D18 leaks. As many...
I recently got my 69 CJ back on the road after many years of sitting.... Prior to doing so I changed/upgraded all of the following. The vehicle...
My altenator is dead in my CJ (225 :v6:). Fortunetly the battery was strong enough to get me home. Only showed 7.8 volts at the battery, and the...
I just started driving my jeep again after many years of it being in torn apart. With the location of reverse on the 3 speed transmission I am...
After 7 years of sitting on jack stands it finally moved today. I installed Cape Conversion HEI, rear gas tank, rebuilt the tcase, and new seals...
How important is the torque bolt? My jeep only has the black rubber mount and I am replacing it with a new rubber mount but the PO removed the...
I am slowly working on getting my CJ back on the road. The project I started today was to inspect/rebuild and OD I picked up on eBay a few years...
Ok... so I am out in the garage doing a D18 rebuild.... Putting on the new brake pads and they seem to be rubbing. i took them out and torqued...
I have read dozens of speedo gear threads on the forum prior to posting... so if I missed it.... maybe I will have better luck searching next...
Build Photos I am trying the near impossible... to get the D18 to stop leaking. I will be replacing the bearings and seals in the D18 and just...
My drive train is currently out of the jeep and was thinking it may be a good time to rebuild the notorious leaking D18 and T14. The last run...
Well it has been several years since I posted on this forum and just as long since I have worked on my jeep. Time to get back at it. I need...
Projection - Analog or Digital (2D)? Forum Search Yet another post about fuel injection on the 225..... I have read lots of great stuff...
I recently had a request for this from an earlier post.... If you have any jeep documents that can be linked.... share the wealth and add them...
Not trying to beat a dead horse here... But I have search and read most of the posts here about flat towing. And after doing so I decided to give...
After being unable to work on my Jeep for over a year I have only 3 weeks to get it all back together before I loose access to the garage I am...
I saw on the Speed Channel the other day a brake "booster" that goes inline with your existing system... It has an electric motor that increases...
mix 140 with multi-purpose grease til you get the consistency of thick honey. Put it in with tube pump. Look at Novak site and there they make...
[img] I need to replace the mainshaft #48 and bearings for dana 18 tcase. There appears to be a lot of "specialty" tools required. Can a...
Separate names with a comma.