Both headlights quit simultaneously. Bulbs both check out. Parking lights, tail lights, turn signals all work. All of the painted labels on my...
My 74 has good power to everything except to starter. Battery has good charge. Jeep runs fine when I jump start it by rolling down driveway and...
Driving along yesterday evening in my 74 (304, Howell TBI) with heater on, and pulled headlight switch on. Everything went dead. No power to...
Never done any brake work, but I have had two master cylinders installed on my 74 (77 frame and running gear) and I still have no brake pedal when...
PO installed new gas tank and filler tube; looks like everything done right. But, I have always had to trickle the gas into the tank or else the...
Thanks again, Tim!
Thanks, Tim. It is actually the draw bar setup that I need pix of; I want to fab a replica for my 74. I did find some on the 3b page; were they...
Need pix of rear bumper(s) that came stock on 72-75 cj5. Thank you.
Thanks Tim; I found exactly what I needed.
I'm trying to de-hack my transmission tunnel sheet metal and shifter boots. Would very much appreciate pix of what stock tunnel sheet metal and...
My T150 3-speed shifts fine when it is cold. After it heats up, it gets harder to shift, particularly when trying to pull it back into first gear...
I've been running the Edelbrock shorties for over a year now and really like them.
Thanks, but I'm ok with my backseat for now. Jim. I wasn't sure my message got sent last night (my laptop battery crapped out just when I hit...
DUI Livewires here too.
Last week's episode of Trucks! on PowerBlock TV (I only watch for the car content, I don't pay any attention to Courtney Hanson) showed them...
Pro-Tools (Tampa, FL) appears to have the best price on an electric bead roller and die sets that I can find. Does anyone have any experience -...
Am going to install the headlight relay upgrade this weekend, and would like to upgrade the lamps at the same time. Does anyone have a headlamp...
Just installed Howell kit on my 304. Love it. Easy install; great product; great service.
Thanks. My plan for the hold down is just mating steel tabs, one on the bracket and one on the floor, with aligned holes and a hitch pin thru the...
I was able to get some used brackets from Collins Brothers for my 74 ($$$) and then put Bestop lowback seats on them. Had to do a little bit of...
Separate names with a comma.