I would like to keep a 35" tire but get one not so wide (having issues with rubbing springs )with the 35x12.5 x 15 tires, was hoping for a 17 or...
Is there any measurement to check on a Dana 27 king pin race or just the obvious (scratches)?
I took my Dana 27 apart to install R&P front disk kit, this is what I found upon inspection: I took apart the knuckles to install new seals...
IF anyone can share there gotcha's while removing/installing a full rear floor. Also looking for factory dimensions to make sure old tub is square...
Looking to find out if anyone has used R&P 4WD disc kit? Looks very similar to herms and is less but I am very aware that cheap things aren't good...
What cars can I pull a 4 barrel intake and carb off of to fit my 225.
Been fiddling with my 68 cj and it will run and idle great. Pretty sure the accelerator pump is still not working properly even after a rebuild,...
I know this is a loaded gun but who has the best fit for the money ?????????????? need a cj 5 rear floor, side panels, tail light panels.
I just rebuilt rochester 2g carb float was sticking and it was missing both check balls. soaked carb in dunk tank washed venturi assembly and...
We just got a 68 cj5, this one was not sitting for 10+ years, it runs and has a bunch of the things we were looking to add. Going to rebuild the...
have a 66 with a dauntless that was sitting for about 10 years, stripped it down to the frame, started to diassemble the motor and it is rusted...
I would like to relocate the gas tank from under driver seat to elsewhere is there anybody who has done this already??
Separate names with a comma.