Thanks!
Hello all, My engine (F-134) had a brass hose barb fitting in the timing cover where the oil filter return line goes in. That brass fitting was...
Thanks! That is perfect. I am going to try and fab something up this weekend. I will try and get some drawings of the parts once I have a...
Can you show a picture of where the driver's side bolts to the floor near the middle of the jeep? I can see where the outside bolt goes, but the...
Hello All, I drove my CJ5 for the first time since beginning my project, even if it was for just a few feet. I need seats. What is the best...
Hello again, A quick question for the forum.... What kind of fitting is it that goes into the bottom of the fuel tank? It appears to be some...
Perfect. Thanks for the tip. I got the front replaced today and hope to do the rear tomorrow. Next up... steering box clean up and new seals....
Hello all again. I am now going to replace the oil seals around the yoke in both differentials. I was able to get the nut off with a pipe wrench...
Anyone have a dorman part number for the right wheel studs or am I going to have to break out the calipers
I have gotten them all removed and are putting the new brakes together. Question: Should I drill out the holes on my new drums to fit over the...
FSM?
Thanks for all the help with my previous thread. I have made significant progress and am almost done with the tear down. I need to remove the...
Alright... It has been a bit but I finally got the engine pulled and the transfer case / transmission dropped out of the jeep. I am in the...
Is there a way to tell if mine is threaded? And if so, how do you unscrew it? Is there an Allen head or something on the side next to the...
Any tricks for pulling that pin? I tried pulling the zerk and threaded a bolt into the hole and hammered on that with no luck. Mine is stuck and...
Thanks for the tips. I have it all loose, but cannot seem to get the trans / tcase and cross member down. The tcase shifters are hitting the...
Thanks all, I got it out this morning, though I am not so sure that the slip yoke did much slipping. Now to drop out the transfer case.
Hello all, I am new here. I tried the search feature but did not find anything terribly helpful. I am in the process of stripping down my 65...
Separate names with a comma.