Well whatever it was..... Broke. Jeep will not start. makes a AWFULL noise when tried to start. so im guessing t in the Flywheel/starter. gues i...
thanks!!!! Where can said manual be found?
Yes with CLutch in and working through the gears it still makes the noise. But it did go away for a few then came back. And it started this the...
Both, Moving ot sitting. In gear or out. Clutch in or out What fluids do the trans and t-case take? Might as well change them
Dont know much about these jeep trannys. i dont even know whats in there? 3 speed. BUt started the jeep yesterday and had an awfull chatter, grind...
Backfiring through the carb is usually a LEAN case. might be a intake leak. or vaccumm leak. get a can of break cleaner and spray it around all...
Not that i have found.... Headers and all the hardwear is 119 and mufflers would be another 80. I would like to run the side pipes. just cuz...
Well im not worried about loud because ANYTHING will be quiter than now. and its already got headers on it. so im assuming new ones should fit no...
Anybody runnnin either of these? http://www.summitracing.com/parts/HED-99190/ http://www.summitracing.com/parts/SUM-G9043/
So on the jeep. 73. its got a 304. The exhasut it has now is all rusted out. its got headers into glasspacks that run and dump before the rear...
o and if the kit doesnt come with bolts. will any grade 8 work fine??
NO major rust as far as i can see. where two of the bolts go through on the floor the body has shifted(due to no mounts) and cracked the floor....
Im going to get the energy suspension kit. Says it has 14 mounts. that sound right? Hope this isnt to much of a pain
Separate names with a comma.
