1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Recent Content by munster

  1. munster
    Post

    Trans swap

    I can get a T176 with a d300. That would put my crawl ratio at about 34 Teralow 3.15 would be about 35 with my current combo. How is the T176...
    Post by: munster, Mar 16, 2010 in forum: Intermediate CJ-5/6/7/8
  2. munster
    Post

    Trans swap

    Thanks guys I had a feeling it would not fit anything else.
    Post by: munster, Mar 15, 2010 in forum: Intermediate CJ-5/6/7/8
  3. munster
    Post

    Trans swap

    No on the auto I was just checking to see if that adapter would adapt the d20 to any other trany. I had the a 340 with the 727 in there when I got...
    Post by: munster, Mar 15, 2010 in forum: Intermediate CJ-5/6/7/8
  4. munster
    Thread

    Trans swap

    Hey all it's been awhile since I've posted. Got the bug again. I have been looking to do some kind of swap to improve my crawl ratio. 304 d20 3.73...
    Thread by: munster, Mar 15, 2010, 7 replies, in forum: Intermediate CJ-5/6/7/8
  5. munster
    Thread

    Driveline help

    Can anybody tell me how to caculate diveshaft angle. My rear is up 9 degrees my t case is down 10 degrees an my driveshaft is at 20 degrees. Any...
    Thread by: munster, May 14, 2005, 0 replies, in forum: Early CJ5 and CJ6 Tech
  6. munster
    Thread

    Slave cylinder mounting

    Is it o.k. to mount a pull type slave cylinder to the frame?
    Thread by: munster, Mar 3, 2005, 1 replies, in forum: Early CJ5 and CJ6 Tech
  7. munster
    Post

    304 or v6 which to use

    I have just started to put a 304 in mine. There isn't a lot of room, I have to notch the front cross member so I can put on the alt. belt and will...
    Post by: munster, Mar 1, 2005 in forum: Early CJ5 and CJ6 Tech
  8. munster
    Post

    where should the engine sit in the frame

    If this pic worked does the tcase look to be in an o.k. spot.
    Post by: munster, Feb 22, 2005 in forum: Early CJ5 and CJ6 Tech
  9. munster
    Post

    where should the engine sit in the frame

    The way it sits now it has 4 degrees up. I think I can raise up the tail end a bit.I am trying to get some pics up but I have to resize haven't...
    Post by: munster, Feb 21, 2005 in forum: Early CJ5 and CJ6 Tech
  10. munster
    Post

    where should the engine sit in the frame

    Thanks for input.
    Post by: munster, Feb 20, 2005 in forum: Early CJ5 and CJ6 Tech
  11. munster
    Thread

    where should the engine sit in the frame

    I'm lost.I am installing a 304 T15 D20 in a 67.There are no mounts just two frame rails. My question is where should the engine sit. Should it be...
    Thread by: munster, Feb 20, 2005, 7 replies, in forum: Early CJ5 and CJ6 Tech
New Posts