I can get a T176 with a d300. That would put my crawl ratio at about 34 Teralow 3.15 would be about 35 with my current combo. How is the T176...
Thanks guys I had a feeling it would not fit anything else.
No on the auto I was just checking to see if that adapter would adapt the d20 to any other trany. I had the a 340 with the 727 in there when I got...
Hey all it's been awhile since I've posted. Got the bug again. I have been looking to do some kind of swap to improve my crawl ratio. 304 d20 3.73...
Can anybody tell me how to caculate diveshaft angle. My rear is up 9 degrees my t case is down 10 degrees an my driveshaft is at 20 degrees. Any...
Is it o.k. to mount a pull type slave cylinder to the frame?
I have just started to put a 304 in mine. There isn't a lot of room, I have to notch the front cross member so I can put on the alt. belt and will...
If this pic worked does the tcase look to be in an o.k. spot.
The way it sits now it has 4 degrees up. I think I can raise up the tail end a bit.I am trying to get some pics up but I have to resize haven't...
Thanks for input.
I'm lost.I am installing a 304 T15 D20 in a 67.There are no mounts just two frame rails. My question is where should the engine sit. Should it be...
So are you saying i shouldn't have to move the crossmember. Just use the 75 grill box. Thanks again
I have decided to put a 304 in my 67. I have been looking back through the fourms and have read that you should or have to move the front cross...
Thanks for the help. The 304 trany is a T 15. Do you think it is a good choice for a trail/street jeep. Also is there a direct swap you can make...
Hello to everyone, I have just purchased my first jeep. It is a 67 cj5 with scout front and rear, 340 727 dana 20 drive drain. I have swaped in...
Separate names with a comma.