came with a bunch of other stuff...length seems close for my saggy convert 1" x 48 spline at shaft side [IMG]
so I have been trying to mock up my stock crossmember in a 70 cj6 with sm420/dana 300 combo. at this point I had to lower the stock crossmember...
i have recently brought home a project cj6, partway through rebuild. much has been done to chassis (225, sm420, dana 300, dana 44/30 w/4.27)....
how can i tell the difference between a 10/19 spline housing and a 30 spline housing. its easy if the axles are installed, but what about when...
'56 cj5 f134 t90 (from a truck with the lower first gear) d18 (from a '67) dana 44 10 spline. 2 1/2 inch lift. t/c crossmember has 2 quarter inch...
i got a vibration/growl when cruising in the "sweet spot" of the throttle. any change in accel or decel (even just a little)and it stops. all...
i recently swapped the small hole dana 18 t/c for a large hole version in my '56 cj5 (f134 t90). now the clutch control tube binds when i tighten...
i was wondering if anyone ever found a source for the old heater motors that fit inside the harrison type heaters with round heater cores. this is...
going to look at a t98 and i was wondering how to tell what engine it may be from. spline count? input shaft length and/or diamater? any info...
anyone know what makes a t14 trans pump its oil into the spicer 18 t case?
i have a shot t14 behind my '69 v6, and a good t14 from a '73 258 in my garage. can i put the 73 t14 behind my v6? swap input shafts? thanks..
input side of a t90 mainshaft, looks lke it ate one of the roller bearings...
brought this home last march, from san diego. My first v6 with an overdrive:). what a difference in power over my little :hurrican:. have since...
looking for thoughts on switching out my front 9 inch brakes on my '56 for some 10's i had laying around. worth it? would i need to swap out the...
were the syncros different in t90s and t86s? this new syncro came with a t86 (t90?!)that i got in pieces. i believe my t86 case held t90 parts...
i broke a bolt as i was installing the clutch cover (pressure plate).are the bolts that hold the clutch cover to the flywheel special? the old...
anyone know what this is and how i might know if its working?
i see letters following the t 90 onsome trannys (i.e. t 90a:t 90c). What's the diff?:?
having trouble ID'n my trnsfr cse. Big hole? Small hole? 26 tooth 6 spline? what's it all mean? in a 56 willys f4 t 90 d18 d44 tapered help...need...
Separate names with a comma.