I had a Weber carb given to me to put on my '74 CJ5 with the 258, to get rid of the old bbd. The carb came on the intake of a jeep 258 intake, so...
I got a slave and master cylinder for a 1980 cj5 with the 2.5 L engine in it, because many of the people that have put a hydro clutch on a mid...
I have a 74 cj5.....and...anyone who has one around the same era knows... the clutch linkage SUCKS! so, I am going to bite the bullet and put a...
I have a 1974 CJ-5 with a 258 inline 6 engine in it. Speedometer says 97,980 miles, but I am not sure that it ha the original engine. I have a...
I have someone interested in a jeep roof I have for sale, which I have it on a 1965 CJ-5. He wants to put it on a 1963 (I thought he said CJ-2,...
All this has taken place on my buddies 79 CJ5 with a 258. Started last Friday (a week ago Friday), he got into so mud, bashed his rear-end and...
This has been much harder than what I have read it would be..... Anyways I have the engine and tranny hooked together inside the jeep, but...
I tore apart my Carter BBD carb a few days ago, and after letting it soak, I went to put it back together tonight. I have torn two other BBDs...
Supposedly, (I have not dug into the differentials to confirm) but what I have read, on my 1963 CJ5, I have a rear Dana 44 with either 10 or 19...
I have done a lot of searching, and about all I have found is that I have to remove the interlock pin (I think its called the pill?) and then that...
This is on my 1963 cj5 134 4 cylinder, with a carter YF carburetor. The original carburetor leaked fuel out of the throttle lever (I believe the...
Hello, I have been referring back to threads posted several times now for my 63 cj-5. I am looking for some more help here.... I took...
Hey yall, I went to get a couple replacement coil resistors for my 74 cj5 (strait 6 258) and my 63 cj5 (4 cyl 134) and I realized that there...
Which do you recommend Overall? Putting selectable (ARB) lockers in the front or rear of Jeep? Which one do you benefit more from? In case it...
I have a 1963 CJ5 that I did a spring over axle lift to. Everything went well except I have no way of dropping the steering down. The steering is...
I get the Dumb-*** award for this one.... R) Tore the body off the 1963 cj5 I am restoring, and never payed attention to where there vacuum...
Anyone know the best place to buy these?............. I am looking for some very skinny, but tall tires for my 63 cj5 4 cylinder. The bigger...
Here's my story: I am currently in the midst of restoring my great grandfather's 1963 CJ-5. I have gone as far as to removing the body off the...
As seen in this picture: http://www.film.queensu.ca/cJ3B/Photos/Tech/Steering/SteeringGear.JPG , I need the bearing that makes up #10 and #11 in...
So I just picked up my great grandfathers 1964 CJ-5 this afternoon for $250. A guy bought a PTO winch off my great uncle and I took the winch off...
Separate names with a comma.