Reinstalled the Warn OD last night on my T90 transmission. After tightening the OD assembly (1/2 drive extension is used to do this), there's a...
FINALLY going to be installing the powertrain tonight (its only been a year)! I've got the new clutch fork and will be bolting everything back...
FINALLY got the engine mounts welded in (only took a year) so I'm motivated again... However,, when trying to get the trans to mate w/the...
Struggled last night when trying to figure out where to locate the advance adapter engine mounts for the v6 install. I've heard that the...
Anyone have any history/suggestions..Jon Stevens (michigan pin stripes) and I were fitting the 225 v6 into my cj2a today. The engine and headman...
Project is swapping a 4 cyl for a 225 on my '48 flatty. 1. T90 trans input shaft won't turn when mated to t-case. Bought, from Herm, the...
Our Jeep had an "F" head and is getting a dauntless engine. Trying to figure out which trans to use. Original engine was a "F" head w/a "short...
Jon and I are going to replace the timing gear tensioner this weekend on the 225 engine/cj5 jeep he just purchased. Any recommendations on...
Been reading many articles on the Solex carbs for 4L & F -134 engines. Haven't seen many much on the Solex for the 225 v-6. Would...
My 7 year old and I went for some rides around "da hood" this past weekend...the grin on his face was almost has big as mine! He loves it and its...
Finally finished upgrading to 11' brakes in the front and got the brake lights to work. Went about a mile down the road and developed a bad...
Well, I think I've done it to myself again....I installed 11" brakes on the front of the Willys. Went for a ride last nigth w/michigan_pinstrips....
Separate names with a comma.