Maybe selling the CJ & going to a old wagon ... :roll: I can't seem to get these thoughts out of my head...help me!!!
With your jeep? Just wondering...I'm gonna be heading down to the delta tomorrow to pick up a 15' fiberglass runabout for a friend, even though...
Off craigslist, for $200.00 :shock: Seemed solid enough & not beat up too bad...here's the link to craigslist but I don't know how long it will...
66 CJ5 D27 I'm assuming it's all a press fit? I've got the drum off.
I'm not sure if it's making any noise when I'm driving but I don't think so. When I'm coming to a stop & push the clutch in, it sometimes sounds...
Mornin guys. I got the R&P dual master conversion done & went to put new shoes & wheel cylinders on the front & found that one of the PO's (maybe...
Reading the instructions in R&PS dual cylinder brake upgrade it says to double flare the existing brake lines. Well, I got started disconnecting...
Since I quit my job Wednesday, I figured I might as well park the jeep in the shade & get the rats nest sorted out that's behind the dash & also...
And for the life of me, I can't get the input shaft to turn...I called Herm earlier today & he told me it was probably just tight :shock: & to pry...
On my 66 when I pulled the tranny & transfer case out, I noticed that the transfer case mount had sheared up near the ear of the transfer case &...
I just got a good look inside my T86 that I was planning on sending to Herm for an upgrade & it's not salvageable...:cry: the housing that holds...
I've been out cleaning the underside of my jeep in anticipation of pulling my transmission & transfer case & eyeballing what else I'm eventually...
1966 with a 225...I'm guessing it has a model 18 transfer case because it has the warn overdrive...what will work?
Browsing though an internet site, I seen a guy wanting to sell his T18 with 4.02 first gear & Dana 20 transfer case for $200...it supposedly came...
I've done about a weeks worth of reading on steering conversions & decided the Saginaw was probably the best way to go...here's a couple pics of...
Why would a person buy a nice painless fuse block & wire it with 4-5 pieces of wire spliced together to reach the switch? I'm also wondering why...
Great site guys...I joined last week because I finally managed to sell my 94 F350 diesel money pit & pick up an older CJ5...(1966) I've been...
Separate names with a comma.