Thanks, That is nice to know
Thanks, Picture take during Earlycj5 Rubicon run in 2011
I bought a '62 CJ5 with a a '95 4.3 engine in it. It had no wires in the jeep and the engine computer wires had a lot cut and the rest just...
A drywall screw in to the end of the seal can provide enough friction to pull it out.
Right side offset.
Does anyone have the number for the outer seal to keep gear lube out of the bearings. I think I would like this better than having the gear lube...
I took the jeep out today. The two rods are hitting with the left front wheel up. A six inch will work . I'm afraid a dropped arm will have...
I have the 3 bolt jeep CJ manual steering box ( was listed for years 72-86) with a standard 7 inch pitman arm. Is it possible to get one that is...
Some where on this site I saw that the wheel hub, locking hubs stud replacement for the bolts was 3/16 by 2 1/2" Locally I have not been able...
Thanks. Notches are actually for lights. Could use one for a step if needed, I guess
[IMG] This is a bumper I've been working on for awhile. Paula finally saw it the night before her wreck. Haven't started on swing arm yet....
I moved to the radiator to the right an inch and 1 1/2 inches down which allowed the fan to clear the hose and port.
I put some extra washers on the shaft next to the brake pedal arm and took a lot of the slop out. Still works well/
I was concerned because I have heard of people breaking axles on the granite faces by having the clutch packs too tight.
I recently put in the D25 axle with powerlok. One day I drove it on the highway with just the front hubs locked. I can now see why it could be...
I would check out the cable first, make sure it is good and lubed properly.
Thank you.
Some time ago I received a D25 ankle as part of another deal. I found out later it had a powerlok universal. I decided to replace my D27 with...
IT may depend on the year. I got the backing plates off a '71 wagoneer that fit my D27.
A few months ago I bought a rear axle because it had a powerlok diff and it matched my 5.38 gears. Along with it was a front axle "for parts" the...
Separate names with a comma.