I have lost the screws that hold the fuse block to the firewall..... does anyone know the size and length of these screw to save me a few trips to...
I am in the process of bodywork on my 75 CJ5 and am considering moving my filler neck to the rear right quarter panel. Has anyone done this...
Recently someone had a post that showed nice rear bumper and swingout tire carrier. I think there is a builder out there making them custom to...
Is there a diff between early and late CJ5 corner guards except for the fuel filler hole ? Does anyone know who makes corner guards without the...
Hey guys some good news but need some help.... After looking hard for a good replacement bodymount/ 1 inch body lift system with no luck, I might...
I'm getting close to the end of my project and would like to Rhino line the inside or something use something similar. My question is should I...
Besides width.... Do some dana 44's come with thicker tubes, pumkins? Basically are some dana 44 rear axles better than others?
Looking to completely redo the dash panel with new gauges. Can't find much for the 72-75 but lots for the 76. Are these panel similar? If not...
Is it posible to run a 35 spline shaft with ARB carrier in a Dana 44 rear diff?
Mechanical or Hydrolic.... What are some opinions? BTW... jeep will be used 80% around town.
What is the best way to match exhaust ports with hedder flanges?
Are the fuel pumps for all AMC V8 engines the same?
Looking for a new alternator and starter for my 401. Anyone have any suggestions of good manufactures?
I just currently had my Dana 20 transfer case rebuilt with Tera Low gears and a new larger 1 3/8”-32 spline rear output shaft to help strengthen...
I have a front sway bar with quick disconnects and I wondered if anyone has run a rear sway bar with quick disconnects? Does it help much with...
What is the best way to remove the knuckles off a Front Axle Dana 44?
Anyone no where I can get a distributor bracket and thermostat housing for AMC V8? Thanks
I am finalizing my 401 build and want to know if there is a hardware kit that replaces all the bolts, washers, nuts, etc? If not.... is there a...
What is the stock front axle width of a 1975 CJ5 Dana 30? What is the stock front axle with of 60ish willys? Did they come with a 30?
Maybe dumb question..... what is the best way to take off the pitman arm from the steering box down shaft?
Separate names with a comma.